Denver Instrument Tl-series Operations Instructions download pdf (Page 32)

Weighing in Percent

Weighing in Percent Code 2 1 5

This application program enables you to obtain weight readouts in percent

which are in proportion to a reference weight. The reference weight readout is

stored as a menu-defined percentage (factory setting: 100%).

Changing the Reference Percentage

You can change the reference percentage in cycles. Choose from the following

settings: 5, 10, 20, 50 and 100.

To activate the Hold down FUNCTION for more than 2 seconds until

change function: “rEF 100%” appears on the display

To change the setting: Briefly press FUNCTION

To store the percentage: Hold down FUNCTION for more than 2 seconds to

store it permanently (in the non-volatile memory)

after you turn off the power

This setting is not canceled by the reset code 9 – – 1°!

Storage Parameter for the Reference Weight/Value Code

With full accuracy according to the internal resolution 3 5 1 *

According to the display accuracy 3 5 2

Display Parameter for Readouts in Percent Code

Without a decimal place 3 6 1

With one decimal place 3 6 2*

With two decimal places 3 6 3

With three decimal places 3 6 4

If the weight stored is too light to be displayed, the number of decimal places

is automatically decreased.

* = factory setting; depends on the balance model in some cases

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 48 49

No comments

Denver Instrument Tl-series Operations Instructions Page 32